Configuration Methods - Digi Connect EZ 4 User Manual

Configuration and management
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Set a new SSID for the digi_ap access point:
(config)> network wifi ap digi_ap ssid new_ssid
(config)>
4. Set a new pre-shared key:
(config)> network wifi ap digi_ap encryption key_psk2 new_key
(config)>
5. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Configuration methods

There are two primary methods for configuring your Connect EZ device:
Web interface.
n
The web interface can be accessed in two ways:
Central management using the Digi Remote Manager, a cloud-based device management
l
and data enablement platform that allows you to connect any device to any application,
anywhere. With the Remote Manager, you can configure your Connect EZ device and use
the configuration as a basis for a profile which can be applied to other similar devices. See
Using Digi Remote Manager
manage and configure your Connect EZ device.
The local web interface. See
l
local web interface to manage and configure your Connect EZ device.
Note Changes made to the device's configuration by using the local web interface will not
be automatically reflected in Digi Remote Manager. You must manually refresh Remote
Manager for the changes to be displayed.
Web-based instructions in this guide are applicable to both the Remote Manager and the local
web interface.
Command line.
n
A robust command line allows you to perform all configuration and management tasks from
within a command shell. Both the Remote Manager and the local web interface also have the
option to open a terminal emulator for executing commands on your Connect EZ device. See
Digi Connect EZ 4/4i User Guide
for more information about using the Remote Manager to
Using the web interface for more information about using the
Configuration methods
47