Digi Connect EZ 4 User Manual page 710

User authentication
iii. Verify that the admin group has Admin access enabled. If not, click Admin access to
enable.
iv. Verify that Access level is set to Full access. If not, select Full access.
7. Click Apply to save the configuration and apply the change.

Command line
1. Configure a user on the RADIUS server:
a. On the ubuntu machine hosting the FreeRadius server, open the /etc/freeradius/3.0/users
file:
$ sudo gedit /etc/freeradius/3.0/users
b. Add a RADIUS user to the users file:
admin1 Cleartext-Password := "password1"
In this example:
n
n
n
c. Save and close the users file.
2. Configure a user on the TACACS+ server:
a. On the ubuntu machine hosting the TACACS+ server, open the /etc/tacacs+/tac_plus.conf
file:
$ sudo gedit /etc/tacacs+/tac_plus.conf
b. Add a TACACS+ user to the tac_plus.conf file:
user = admin1 {
}
In this example:
n
n
Digi Connect EZ 4/4i User Guide
Unix-FTP-Group-Names := "admin"
The user's username is admin1.
The user's password is password1.
The authentication group on the Connect EZ device, admin, is identified in the
Unix-FTP-Group-Names parameter.
name ="Admin1 for TX64"
pap = cleartext password1
service = system {
groupname = admin
}
}
The user's username is admin1.
The user's password is password1.
Example user configuration
710