Show Nemo Status - Digi Connect EZ 4 User Manual

Virtual Private Networks (VPN)
n
The default is defaultroute.
12. Set the GRE tunnel local endpoint:
a. Set the method to determine the GRE tunnel local endpoint:
(config vpn nemo nemo_example)> tun_local type value
(config vpn nemo nemo_example)>
where value is one of:
n
n
The default is defaultroute.
13. Configure one or more local networks to use as a virtual NEMO network interface. Generally,
this will be a Local Area Network (LAN):
a. Add a local network to use as a virtual NEMO network interface:
(config vpn nemo nemo_example)> add network end eth2
(config vpn nemo nemo_example)>
b. (Optional) Repeat for additional interfaces.
14. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
15. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Show NEMO status


WebUI
Digi Connect EZ 4/4i User Guide
ip
If ip is used, set the IP address:
(config vpn nemo nemo_example)> coaddress address IP_address
(config vpn nemo nemo_example)>
defaultroute: Uses the same network interface as the default route.
interface
If interface is used, set the interface.
i. Use the ? to determine available interfaces:
ii. Set the interface. For example:
(config vpn nemo nemo_example)> tun_local interface eth1
(config vpn nemo nemo_example)>
NEMO
485