Digi Connect EZ 4 User Manual page 234

Wi-Fi
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Edit an existing Access point
1. Log into the Connect EZ command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Show available access points:
(config)> network wifi ap ?
Additional Configuration
------------------------------------------------------------------------
-------
digi_ap
(config)>
4. Set the SSID for the appropriate access point:
(config)> network wifi ap digi_ap ssid my_SSID
(config)>
5. SSID broadcasting is enabled by default for the preconfigured access points. If SSID
broadcasting is disabled:
(config)> network wifi ap digi_ap ssid_broadcast true
(config)>
6. Set the security for the access point to a personal security option:
(config network wifi ap new_AP)> encryption type value
(config network wifi ap new_AP)>
where value is one of:
psk: Uses WPA Personal (PSK). All Wi-Fi clients must support WPA to be able to
n
authenticate.
mixedpsk: Uses mixed WPA/WPA2 Personal (PSK) mode. Wi-Fi clients that support WPA
n
and WPA2 are able to authenticate.
psk2: Uses WPA2 Personal (PSK) mode. All Wi-Fi clients must support WPA2 to be able
n
to authenticate.
psk2sae: Uses WPA2-PSK/WPA3-AES mixed mode. Wi-Fi clients that support WPA2 and
n
WPA3 are able to authenticate.
Digi Connect EZ 4/4i User Guide
Configure a Wi-Fi access point with personal security
Digi AP
234