Set The Monitors To Show As A Bar Graph - YASKAWA HV600 Technical Reference

◆

Set the Monitors to Show as a Bar Graph

The procedure in this section shows how to show the frequency reference monitor as a bar graph.
1.
Push (Home) to show the HOME screen.
Note:
• The keypad will show [Home] in the top right corner when the HOME screen is active.
• If [Home] is not shown on
2.
Push (Menu).
3.
Push or
4.
Push or
5.
Push or
6.
Push .
7.
Push or
Enter the three digits in "x-xx" part of monitor Ux-xx to identify which monitor to output. For example, to show
monitor U1-01 [Frequency Reference], set it to "101" as shown in this figure.
YASKAWA SIEPYAIH6B01A HV600 AC Drive Bypass Technical Reference
, push (Back) to show [Home] on
to select [Monitors], then push
to select [Bar Graph], then push
to select the location to store the monitor, then push
to select the monitor number to register, then push
.
.
(Setup).
.
.
4.4 Keypad Operation
135
4