YASKAWA HV600 Technical Reference page 98

3.5 Bypass PCB Control Circuit
Note:
• Refer to Figure 3.13 for information to prepare terminal ends of the shielded wire.
• Prepare the wire ends of shielded twisted-pair wires as shown in
frequency setting potentiometer to set the frequency. Connect the shield to TB2-11 or TB2-12 on the bypass control board or
terminal FE on the drive.
A - Connect the shield to TB2-11 or TB2-12.
B - Sheath
2.
Install the front cover to its initial position.
98
C - Insulate with electrical tape or shrink tubing.
Figure 3.13 Prepare the Ends of Shielded Wire
Figure 3.13 to use an analog reference from an external
YASKAWA SIEPYAIH6B01A HV600 AC Drive Bypass Technical Reference