YASKAWA HV600 Technical Reference page 277

■
H2-03: Term M5-M6 Function Selection
No.
Name
(Hex.)
H2-03 Term M5-M6 Function
Selection
(040D)
Note:
When you do not use this terminal, or when you will use the terminal in through mode, set this parameter to F.
■
H2-06: Watt Hour Output Unit Selection
No.
Name
(Hex.)
H2-06 Watt Hour Output Unit
Selection
(0437)
This output is input to the Watt hour meter or PLC through a 200 ms pulse signal. This parameter sets the kWh unit
for each pulse output.
Note:
• When the power value is a negative value (regenerative state), the drive does not count Watt hours.
• When the control power supply to the drive is operating, the drive will keep the Watt hours. If a momentary power loss causes the drive to
lose control power, the Watt hour count will reset.
0 : 0.1 kWh units
1 : 1 kWh units
2 : 10 kWh units
3 : 100 kWh units
4 : 1000 kWh units
■
H2-07: Modbus Register 1 Address Select
No.
Name
(Hex.)
H2-07 Modbus Register 1 Address
Select
(0B3A)
Sets the address of the register that is output to Modbus Reg 1 Status Satisfied [H2-01 to H2-03 = 62] and uses the bit
in H2-08 [Modbus Register 1 Bit Select].
■
H2-08: Modbus Register 1 Bit Select
No.
Name
(Hex.)
H2-08 Modbus Register 1 Bit
Select
(0B3B)
Sets the bit of the register that is output to Modbus Reg 1 Status Satisfied [H2-01 to H2-03 = 62] and uses the address
in H2-07 [Modbus Register 1 Address Select].
YASKAWA SIEPYAIH6B01A HV600 AC Drive Bypass Technical Reference
Sets the function for MFDO terminal M5-M6.
Sets the unit for the output signal when H2-01 to H2-03 = 39 [MFDO Function Selection = Watt
Hour Pulse Output].
Figure 5.45 Example MFDO when Configured for Watt Hours
Sets the address of the MEMOBUS/Modbus register output to the MFDO terminal.
Sets the bit of the MEMOBUS/Modbus register output to the MFDO terminal.
Description
Description
Description
Description
5.7 H: Terminal Functions
Default
(Range)
2
(0 - 1FF)
Default
(Range)
0
(0 - 4)
Default
(Range)
0001
(0001 - 1FFF)
Default
(Range)
0000
(0000 - FFFF)
277
5