YASKAWA HV600 Technical Reference page 275

Setting Value
72 High PI2 Control Feedback Level
89 Output Current Lim
94 Loss of Prime
95 Thermostat Fault
96 High Feedback
97 Low Feedback
9E Low PI Auxiliary Control Level
9F High PI Auxiliary Control Level
A9 RELAY Operator Control
AB Thrust Mode
AC Setpoint Not Maintained
B2 BAS Interlock
B8 Pump Fault
B9 Transducer Loss
*1 Inverse output is not available.
*2 You cannot set this parameter on models D169 to D273, A154 to A248, and B065 to B302.
■
Extended MFDO1 to MFDO3 Function Selection
You can set MFDO functions to bit 0 to bit 2 [MEMOBUS MFDO1 to 3] of MEMOBUS register 15E0 (Hex.). Use
H2-40 to H2-42 [Mbus Reg 15E0h bit0 to bit2 Output Func] to select the function.
Figure 5.43 Functional Block Diagram of MEMOBUS Multi-function Output
Register number
(Hex.)
15E0
Note:
• Refer to
MFDO Setting Values on page 280
• When you do not set functions to H2-40 to H2-42, set them to F.
■
Output of Logical Operation Results of MFDO
This enables the logical operation results of two MFDOs to be output to one MFDO terminal.
Use H2-60, H2-63, and H2-66 [Term M1-M2 Secondary Function to Term M5-M6 Secondary Function] to set the
function of the output signal for which logical operations are performed.
Use H2-61, H2-64, H2-67 [Term M1-M2 Logical Operation to Term M5-M6 Logical Operation] to set the logical
operation.
YASKAWA SIEPYAIH6B01A HV600 AC Drive Bypass Technical Reference
Function Reference
290
291
291
291
291
291
291
291
291
291
291
292
292
292
Table 5.41 MEMOBUS MFDO Registers
for more information about MFDO setting values.
Setting Value
BA PI Auxiliary Control Active
BB Differential Feedback Exceeded
BC Sleep Active
BD Start Delay
BE Pre-Charge
C0 HAND Mode
C1 AUTO Mode
C2 OFF Mode
C3 Main Feedback Lost
C4 Backup Feedback Lost
Inverse Outputs of 0 to C4
Sets an inverse output of the function for the MFDO.
100 to 1C4
Put a 1 at the front of the function setting to set inverse
output. For example, set 138 for inverse output of 38
[Drive Enabled].
Name
bit0 MEMOBUS MFDO 1
bit1 MEMOBUS MFDO 2
bit2 MEMOBUS MFDO 3
5.7 H: Terminal Functions
Function Reference
292
292
292
292
292
292
293
293
293
293
293
5
275