YASKAWA HV600 Technical Reference page 307

Note:
• Setting range differs by protocol:
–BACnet: 3, 4, 5, 7
–P1: 2, 3
–N2: 3
–Modbus: 0 to 8
• Re-energize the drive or set H5-20 = 1 [Communication Parameters Reload = Reload Now] after you change the parameter setting.
0 : 1200 bps
1 : 2400 bps
2 : 4800 bps
3 : 9600 bps
4 : 19.2 kbps
5 : 38.4 kbps
6 : 57.6 kbps
7 : 76.8 kbps
8 : 115.2 kbps
■
H5-03: Communication Parity Selection
No.
Name
(Hex.)
H5-03 Communication Parity
Selection
(0427)
Note:
Re-energize the drive or set H5-20 = 1 [Communication Parameters Reload = Reload Now] after you change the parameter setting.
0 : No parity
1 : Even parity
2 : Odd parity
■
H5-04: Communication Error Stop Method
No.
Name
(Hex.)
H5-04 Communication Error Stop
Method
(0428)
0 : Ramp to Stop
The drive ramps the motor to stop in the deceleration time. Fault relay output terminal MA-MC activates and MB-MC
deactivates.
1 : Coast to Stop
The output turns off and the motor coasts to stop. Fault relay output terminal MA-MC turns activates and MB-MC
deactivates.
2 : Fast Stop (Use C1-09)
The drive stops the motor in the deceleration time set in C1-09 [Fast Stop Time]. Fault relay output terminal MA-MC
activates and MB-MC deactivates.
3 : Alarm Only
The keypad shows a CE [Modbus Communication Error] alarm and the drive continues operation. The output
terminal set for Alarm [H2-01 to H2-03 = 10] activates.
4 : Run at H5-34 (CE Go-To-Freq)
The keypad shows a CE [Run at H5-34 (CE Go-To-Freq)] alarm and the drive will operate at the speed set in H5-34
[Comm Error (CE) Go-To-Frequency] when a Communication Error condition occurs.
YASKAWA SIEPYAIH6B01A HV600 AC Drive Bypass Technical Reference
Sets the communications parity used for MEMOBUS/Modbus communications.
Sets the motor Stopping Method when the drive detects a Modbus Communication Error condition.
Description
Description
5.7 H: Terminal Functions
Default
(Range)
0
(0 - 2)
Default
(Range)
3
(0 - 4)
307
5