YASKAWA HV600 Technical Reference page 100

3.6 Drive PCB Control Circuit
Figure 3.15 Tightening Torque Display Location (Reverse Side of Drive Front Cover)
Figure 3.16 Tightening Torque Display Location (Lower Front Side of Drive Front Cover)
◆
Control Circuit Wire Gauges and Tightening Torques
Use the tables in this section to select the correct wires. Use shielded wire to wire the control circuit terminal block.
Use crimp ferrules on the wire ends to make the wiring procedure easier and more reliable.
Drive
Terminal Terminal
Block
TB1 +V, AC, A1, A2, FM
TB3 AM, AC, S1 - S7
TB4 SN, SC, SP, +P
TB5 SN, HC, H1, H2
TB6 AC, D+, D-, PS
TB7 MA, MB, MC, M1 - M6
TB2 FE
100
Table 3.20 Control Circuit Wire Gauges and Tightening Torques
Tightening Torque
Screw Size
N∙m (in∙lb)
0.5 - 0.6
(4.4 - 5.3)
M3
1.0 - 1.2
(8.85 - 10.62)
Bare Wire
Recommended
Applicable Gauge
Gauge
2
mm (AWG)
mm 2 (AWG)
Stranded wire:
0.25 - 1.5
0.75 (24 - 16)
(18) Solid wire:
0.25 - 1.5
(24 - 16)
Stranded wire:
0.12 - 0.75
0.75 (26 - 18)
(18) Solid wire:
0.2 - 1.5
(26 - 16)
YASKAWA SIEPYAIH6B01A HV600 AC Drive Bypass Technical Reference
Crimp Ferrule
Recommended
Applicable Gauge
Gauge
2
mm (AWG)
mm 2 (AWG)
0.75 0.25 - 1.5
(18) (24 - 16)
0.75 0.25 - 1.5
(18) (24 - 16)