YASKAWA HV600 Technical Reference page 562

8.4 Replace Drive Cooling Fans and Circulation Fans
2.
Pull the cooling fan straight up from the drive. Remove the protective tube on the power supply connector and
disconnect the connector to remove the fan from the drive.
A - Cooling fan
■
Install a Cooling Fan
Reverse the removal procedure to install a cooling fan.
1.
Connect the drive and the fan connectors, and attach the protective tube.
A - Protective tube
2.
Align the notches on the fan with the pin on the drive and install the cooling fan in the drive.
Note:
The positions of notch on the fan and alignment pin on the drive are different for different drive models. Use these figures to make
sure that you use correct positions for your drive.
A - Notch on fan
B - Alignment pin on drive
Figure 8.4 Install the Cooling Fan (Drive Models: 2011, 2017, 4011, 4014)
562
B - Protective tube
Figure 8.2 Remove the Cooling Fan
Figure 8.3 Connect the Power Supply Connector
C - Front of drive
YASKAWA SIEPYAIH6B01A HV600 AC Drive Bypass Technical Reference