YASKAWA HV600 Technical Reference page 269

Signal Input Method from
Peripheral Devices
Setting
N.O.
23 -
24 x
25 -
26 x
27 -
28 x
29 -
2A x
2B -
2C x
2D -
2E x
2F -
*1 Set the terminal to N.O. (detects external fault when switched ON) or N.C. (detects external fault when switched OFF).
*2 Set the drive to always detect each fault or to detect only during run.
■
30: PID Integrator Reset
Setting Value Function
30 PID Integrator Reset
Note:
Refer to "PID control block diagram" for more information.
■
31: PID Integrator Hold
Setting Value Function
31 PID Integrator Hold
When you turn off the input terminal, PID control restarts the integral.
Note:
Refer to "PID control block diagram" for more information.
■
34: PID Soft Starter Disable
Setting Value Function
34 PID Soft Starter Disable
ON : Disabled
Disables b5-17 [PID Accel/Decel Time].
OFF : Enabled
Enables b5-17 [PID Accel/Decel Time].
Note:
Refer to "PID control block diagram" for more information.
■
35: PID Input (Error) Invert
Setting Value Function
35 PID Input (Error) Invert
YASKAWA SIEPYAIH6B01A HV600 AC Drive Bypass Technical Reference
External Fault Detection Method
*1 *2
Always Detected during
N.C.
Detected RUN Only
x -
- x
x x
- -
x -
- x
x x
- -
x -
- x
x x
- -
x -
Sets the command to reset and hold the PID control integral to 0 when the terminal is ON.
Sets the command to hold the integral value of the PID control while the terminal is activated.
Sets the PID soft starter function.
Sets the command to turn the terminal ON and OFF to switch the PID input level (polarity).
Ramp to Stop Coast to Stop
(Fault) (Fault)
x x
- -
- -
x -
x -
- -
- -
x -
x -
- -
- -
x -
x -
Description
Description
Description
Description
5.7 H: Terminal Functions
Stopping Method
Continuous
Fast Stop
Operation
(Fault)
(Alarm Only)
- -
x -
x -
x -
x -
- x
- x
- x
- x
- -
- -
- -
- -
-
-
-
-
-
-
-
-
-
x
x
x
x
5
269