YASKAWA HV600 Technical Reference page 267

Note:
• To use the N.C. switch to input the fast stop command, set 17 (Fast Stop (N.C.)).
• Refer to
C1-09: Fast Stop Time on page 228
• Set C1-09 [Fast Stop Time] to a correct deceleration time. If the deceleration time is too short, it can cause an overvoltage fault and failure
to stop the motor from coasting.
■
17: Fast Stop (N.C.)
Setting Value Function
17 Fast Stop (N.C.)
If you cancel the fast stop input, the drive will not restart the motor until you meet these conditions:
• Fully stop the motor
• Cancel the Run command
• Cancel the fast stop command
Note:
• To use the N.O. switch to input the fast stop command, set 15 (Fast Stop (N.O.)).
• Refer to
C1-09: Fast Stop Time on page 228
• Set C1-09 [Fast Stop Time] to a correct deceleration time. If the deceleration time is too short, it can cause an overvoltage fault and failure
to stop the motor from coasting.
Figure 5.41 shows an example of how fast stop operates.
C1-09: Fast Stop Time
■
18: Timer Function
Setting Value Function
18 Timer Function
Note:
Refer to "b4: Timer Function" for more information.
■
19: PID Disable
Setting Value Function
19 PID Disable
ON : PID control disabled
OFF : PID control enabled
■
1B: Programming Lockout
Setting Value Function
1B Programming Lockout
YASKAWA SIEPYAIH6B01A HV600 AC Drive Bypass Technical Reference
for more information.
Sets the command to ramp to stop in the deceleration time set in C1-09 [Fast Stop Time] when the input terminal is activated while
the drive is operating.
for more information.
Figure 5.41 Fast Stop Time Chart
Sets the command to start the timer function. Use this setting with Timer Output [H2-xx = 12].
Sets the command to disable PID control when b5-01 = 1 or 3 [PID Mode Setting = Standard or Fref + PID Trim].
Sets the command to prevent parameter changes when the terminal is OFF.
5.7 H: Terminal Functions
Description
Description
Description
Description
5
267