Enable A Telnet Connection On The Serial Port - Digi Connect IT 4 User Manual

Configure Connect IT using the web user interface
3. Expand the Serial section.
4. Expand the port that you want to configure: Port 1, Port 2, Port 3, or Port 4.
5. Expand the Monitor section.
6. Configure the settings.
Setting
CTS
DCD
7. Click Save.

Enable a Telnet connection on the serial port

You can enable a Telnet connection on the serial port.
1. Log in to the Connect IT web
2. Click Configuration in the left pane.
3. Expand the Serial section.
4. Expand the port that you want to configure: Port 1, Port 2, Port 3, or Port 4.
5. Expand the Telnet connection section.
6. Configure the settings.
Setting
Enable
Port
7. Specify the addresses, interfaces, and firewall zones which are allowed to access the serial
port. Expand the Access control list.
Digi Connect IT® 4 User Guide
Description
Select the CTS option to monitor CTS changes on this port.
Select the DCD option to monitor DCD changes on this port.
UI.
Description
Select the Enable option to allow the serial port to be directly
accessed by a Telnet connection.
WARNING! This connection is not authenticated
or encrypted.
Specify the Telnet port for the service.
Minimum value: 1
Maximum value: 65535
Default: 2001
Configure a serial port
36