Anl-24-L (24-Port Analog Line) - Avaya Definity SI Maintenance Manual

Maintenance Object Repair Procedures

ANL-24-L (24-Port Analog Line)

MO Name (in
Alarm Log)
ANL-24-L
ANL-24-L
1 Where P is the port network number (1 for PPN); C is the carrier designation (for
example, A, B, or C); SS is the address of the slot in the carrier where the circuit pack is
located (for example, 01, 02, etc.); and pp is the 2-digit port number (for example, 01).
The 24-Port Analog Line circuit pack (TN793) provides 24 ports for voice
terminals and supports both on-premises and off-premises analog voice
terminals.
No maintenance of the terminal connected to the 24-Port Neon Analog Line circuit
pack is performed, except to determine whether or not the terminal is connected.
Failures of the neon message waiting lamp power and the common ringing
application circuitry are reported as part of common port circuit pack errors. See
errors 1281 and 1793 in the "XXX-BD (Common Port Circuit Pack)" section.
NOTE:
This analog line circuit pack supports analog data modules. When assigned,
analog data modules provide access to the NetPkt (TN2401/TN794) data
ports. To activate an analog data module you must assign the port location
on the data form and connect a modem to the port. (The analog data
module may be used for connection to a CDR output or other adjuncts as
needed.) These ports are tested the same as all other analog ports on the
circuit pack.
Ringing Caused by Maintenance Testing
Test #48 may cause some terminal equipment to ring briefly during daily
maintenance. If this ringing is disturbing the customer or the terminal equipment, it
should be disabled in the Tests field of the change station extension form. Be
aware that this action also disables Tests #6, 7, 161, and 35.
10-44 Issue 4 May 2002
Initial Command to
Alarm Level
MIN test port PCSSpp l
WRN test port PCSSpp sh
Full Name of MO
1
Run
24-Port Analog Line
24-Port Analog Line
555-233-123