Anl-24-L (24-Port Analog Line) - Avaya S8700 Maintenance Manual

ANL-24-L (24-Port Analog Line)

ANL-24-L (24-Port Analog Line)
MO's Name (in
Alarm Log)
ANL-24-L
ANL-24-L
1. UU is the universal cabinet number (1–64 for ATM PNC, 1–44 for CSS PNC). C is the carrier
designation (A, B, C, D, or E). SS is the number of the slot where the circuit pack resides (01–21).
pp is the 2-digit port number (01, 02,...).
The 24-Port Analog Line circuit pack (TN793) provides 24 ports for voice
terminals and supports both on-premises and off-premises analog voice
terminals.
No maintenance of the terminal connected to the 24-Port Neon Analog Line circuit
pack is performed, except to determine whether or not the terminal is connected.
Failures of the neon message waiting lamp power and the common ringing
application circuitry are reported as part of common port circuit pack errors. See
errors 1281 and 1793 in
NOTE:
This analog line circuit pack supports analog data modules. When
assigned, analog data modules provide access to the NetPkt (TN794) data
ports. To activate an analog data module you must assign the port location
on the data form and connect a modem to the port. (The analog data
module may be used for connection to a CDR output or other adjuncts as
needed.) These ports are tested like any other analog port on the circuit
pack.
Ringing Caused by Maintenance Testing
Test #48 may cause some terminal equipment to ring briefly during daily
maintenance. If this ringing is disturbing the customer or the terminal equipment,
it should be disabled in the Test? field of the change station extension form.
Be aware that this action also disables Tests #6, 7, 161, and 35.
555-233-143
Alarm Level Initial Command to Run
MINOR test port UUCSSpp l
WARNING test port UUCSSpp sh
''XXX-BD (Common Port Circuit
1
Full Name of MO
24-Port Analog Line
24-Port Analog Line
Pack)''.
Issue 1 May 2002 8-63