Default-Information Originate - D-Link DES-7200 Cli Reference Manual

DES-7200 CLI Reference Guide
Examples
37.1.7

default-information originate

Use this command to generate a default route to the OSPF routing domain in the routing
process mode. The no form of this command disables the default route.
default-information originate [always] [metric
map-name]
no default-information originate [always] [metric] [metric-type] [route-map map-name]
Parameter
settings
Default
Command
mode
Usage
guideline
The example below restarts the OSPF process.
en
clear ipv6 ospf process
Parameter Description
(Optional)
always unconditionally, no matter whether the default
route exists locally or not.
(Optional) Initial metric value of the default route, 1
metric metric
by default
(Optional) Type of the default route. There are two
type of OSPF external routes: type 1, different
metrics seen on different routers; type 2, the same
metric-type
type metric sees on different routers. External route of
type 1 is more trustworthy than that of type 2. By
default, it is type 2.
route-map Associated
map-name route-map by default
None
Routing process configuration mode
When the redistribute or default-information command is
executed, the OSPF-enabled router automatically turns into the
autonomous system border router (ASBR). But the ASBR cannot
generate default route automatically or advertise it to all the routers in
the OSPF routing domain. The ASBR generates default routes by
default. It is required to configure with the default-information
Chapter 37 OSPFv3 Configuration Commands
metric ] [metric-type
Generate the
route-map name,
type ] [route-map
default route
no associated
37-7