D-Link DES-7200 Cli Reference Manual page 1112

Chapter 60 RLDP Configuration Command
Default
Command
mode
Usage
guidelines
Examples
Related
commands
60.1.5 rldp reset
Use this command to make all the ports that have been handled using rldp shutdown or
disable to perform RLDP detection again.
rldp reset
Parameter
description
Default
60-4
bidirection-detect
loop-detect
warning
shutdown-svi
shutdown-port
block
N/A.
Interface configuration mode.
The RLDP detection on the port takes effect only when the global
RLDP is enabled.
The following example demonstrates how to configure RLDP
detection on fas 0/1, specify the detection type as loop detection, and
troubleshooting method as block.
DES-7210(config)# interface fas 0/1
DES-7210(config-if)# rldp port loop-detect block
Command Description
rldp enable Enable RLDP globally.
N/A.
N/A.
DES-7200 CLI Reference Guide
Set bidirectional link detection.
Set loop detection type.
Warn the user.
Shutdown the SVI the port belongs to.
Shutdown the port.
Disable the learning-forwarding function of the
port.