Ip Igmp Snooping Source-Check Port - D-Link DES-7200 Cli Reference Manual

Chapter 16 IGMP Snooping Configuration Commands
Command
mode
Usage
guidelines
Examples
Related
commands

16.1.14 ip igmp snooping source-check port

The source port check function is used to permit one or several IPMC flows from the mroute
port.
To configure the source port check function of IGMP snooping, execute the ip igmp
snooping source-check port command in the global configuration mode. The no form of
this command is used to disable the source port check function.
ip igmp snooping source-check port
no ip igmp snooping source-check port
Parameter
description
Default
Command
mode
Usage
guidelines
16-12
Global configuration mode.
The source IP address check function takes effect globally. Once it is
enabled, only the IPMC streams from the specified IP address are
permitted. The device allows users to configure the source IP
address of all IPMC streams, called default multicast server. The
default server must be set as long as the source IP address check
function is enabled.
The following example shows how to enable the multicast source IP
address check function and configure a default source IP address.
DES-7210(config)# ip igmp snooping source-check default-server
192.168.4.243
Command
Ip igmp snooping
limit-ipmc vlan server
N/A.
Disabled.
Global configuration mode.
The source port check function takes effect globally. Once it is
enabled, only the IPMC streams from the specified port are permitted.
DES-7200 CLI Reference Guide
Description
Add an entry to the source IP
check table.