Mpls Ldp Hello-Interval - D-Link DES-7200 Cli Reference Manual

Chapter 42 MPLS Configuration Commands
Command
mode
Usage
guidelines
Examples
Related
commands

42.1.17 mpls ldp hello-interval

Use this command to configure the holdtime in seconds for LDP hello packets on each
interface. Use the no form of this command to restore the default value.
mpls ldp hello-interval <
no mpls ldp hello-interval
Parameter
description
42-16
Interface configuration mode.
This command is valid only for the LDP Link Hello for the basic
discovery mechanism and possible lead to changes of interval of
sending Hello messages. Use discovery targeted-hello command to
set the hello holdtime for the exteded discovery mechanism.
DES-7210(config)# interface vlan 10
DES-7210(config-if)# mpls ldp hello-holdtime 30
Command
mpls ldp
hello-interval
discovery
targeted-hello
1-65535 >
Parameter
<1-65535>
DES-7200 CLI Reference Guide
Description
Configure the interval for sending hello
messages
Configure the interval and timeout time of
sending hello messages for the extended
discovery mechanism.
Description
Send the interval for hello messages, in
second.