Ip Igmp Snooping Source-Check Default-Server - D-Link DES-7200 Cli Reference Manual

DES-7200 CLI Reference Guide
Default
configuration
Command
mode
Usage
guidelines
Examples
Related
commands

16.1.13 ip igmp snooping source-check default-server

The source IP address check is used to permit one or several IPMC flows from the server of
the specified IP address.
To configure the source IP address check function of IGMP snooping, execute the ip igmp
snooping source-check default-server command in the global configuration mode. The
no form of this command is used to disable the source IP address check function.
ip igmp snooping source-check default-server address
no ip igmp snooping souce-check
Parameter
description
Default
Chapter 16 IGMP Snooping Configuration Commands
10s.
Global configuration mode.
You can specify the time for the switch to wait for the member join
message after receiving the query message. If the switch does not
receive the member join message in the specified time, it considers
that the member has left and then deletes the member. This
command lets you adjust the waiting time after receiving the query
message.
Set the aging time of the routing interface that the switch learns
dynamically to 100s.
DES-7210(config)# ip igmp snooping query-max-response-time 100
Command
ip igmp snooping
Parameter Description
Default multicast source IP address (IP address
address
of the default multicast server)
Disabled.
Function
Configure a multicast routing
interface.
16-11