Topology Guard - D-Link DES-7200 Cli Reference Manual

DES-7200 CLI Reference Guide
61
61.1 Configuration Related Commands
61.1.1

topology guard

In the global configuration command mode, use this command to enable the topology
protection function. Use the no form of this command to disable the topology protection
function.
[no] topology guard
Default
configuration
Command
mode
Usage
guidelines
Examples
Related
commands
TPP
Commands
Enabled.
Global configuration mode.
The topology protection function is enabled by default, so as to
protect the network against topology oscillation due to attacks. It
should be used with the cpu topology-limit command.
The following example shows how to enable and disable the global
topology protection function:
DES-7210(config)# topology guard
DES-7210(config)# no topology guard
Command
tp-guard port enable
cpu topology-limit
Chapter 61 TPP Configuration Commands
Configuration
Description
Enable the topology protection function on
the interface.
Set the CPU utilization limitation.
61-1