D-Link DES-7200 Cli Reference Manual page 388

Chapter 31 RIP Configuration Commands
passive-interface {default | interface-type interface-num}
no passive-interface {default | interface-type interface-num}
Parameter
description
Default
configuration
Command
mode
Usage
guidelines
Examples
Related
commands
Platform
description
31-28
Parameter Description
Default Set the interface to a passive interface.
interface-type Interface type and number
interface-num
No ports are set to the passive mode.
Routing process configuration mode.
The passive-interface default command sets all interfaces to the
passive mode. You can use no passive-interface intface-type
interface-num to set the specified interface to the non-passive mode.
When you enable receiving and sending RIP messages on the
interface with the ip rip send enable and ip rip receive enable
commands, this command sets the interface to the passive mode.
Consequently, receiving RIP update messages rather than sending
RIP update messages is enabled on the interface. However, the ip
rip send enable and ip rip receive enable commands determine
whether the messages can be sent or received.
Set all interfaces to the passive mode and then set ethernet0/0 to the
non-passive mode.
DES-7210(config-router)# passive-interface default
DES-7210(config-router)# no passive-interface gigabitEthernet 4/1
Command
ip rip receive
enable
ip rip send enable
N/A.
DES-7200 CLI Reference Guide
Description
Enable receiving RIP packets on the interface.
Enable sending RIP packets on the interface.