Dot1X Auto-Req Packet-Num - D-Link DES-7200 Cli Reference Manual

Chapter 44 802.1X Configuration Commands
Related
commands
44.1.2

dot1x auto-req packet-num

Use this command to set the number of authentication request messages that the device
automatically sends. The no form is used to specify the default value.
dot1x auto-req packet-num num
no dot1x auto-req packet-num
Parameter
description
Default
Command
mode
Usage
guidelines
Examples
Related
44-2
User-Detect : Enabled
Packet-Num : 0
Req-Interval: 30 Second
Command
show dot1x auto-req
Parameter Description
Number of authentication request messages that
num
the device sends automatically.
num = 0; namely the packets are sent continuously.
Global configuration mode.
Use the show dot1x auto-req command to view the setting of this
function.
The following example sets the device to automatically initiate 802.1x
authentication continuously:
DES-7210# configure terminal
DES-7210(config)# dot1x auto-req packet-num 0
DES-7210(config)# end
DES-7210# show dot1x auto-req
Auto-Req: Enabled
User-Detect : Enabled
Packet-Num : 0
Req-Interval: 30 Second
Command Description
DES-7200 CLI Reference Guide
Description
Show the automatic authentication
request information.