Ip Multicast-Rpf - D-Link DES-7200 Cli Reference Manual

Chapter 41 Multicast Routing Configuration Commands
Usage
guideline
Examples
Note
41.1.7

ip multicast-rpf

Use this command to configure the RPF checking mode of the multicast route.
ip multicast-rpf rpf-mode
no ip multicast-rpf
Parameter
description
Default
Command
mode
41-6
This command allows you to enable IPv4 multicast routing
forwarding. The multicast protocol will not be enabled with IPv4
multicast routing forwarding disabled.
Note:
For DES-7200 series, the IPv4 multicast routing forwarding and
SVGL, IVGL-SVGL modes of IGMP SNOOPING are exclusive. You
shall ensure that the SVGL, IVGL-SVGL modes of IGMP SNOOPING
are disabled before enabling the multicast routing forwarding, or it
prompts: ip multicast-routing conflicts with SVGL mode of IGMP
The IPv4 multicast routing forwarding can be co-used with
SNOOPING!
the IGMP SNOOPING IVGL mode, but the source IP check function
cannot be enabled.
This command enables multicast routing forwarding.
DES-7210(config)# ip multicast-routing
It is not recommended to configure different v4 multicast routing
protocols on different interfaces of a device.
Parameter
rpf-mode
The default mode is SVI.
Global configuration mode.
DES-7200 CLI Reference Guide
Description
Routed-port: Check the routed port by
the upstream interface;
SVI: Check the SVI by the upstream
interface.