Passive-Interface; Redistribute - D-Link DES-7200 Cli Reference Manual

DES-7200 CLI Reference Guide

32.1.39 passive-interface

Use this command to configure the specified network interface or all interface as the
passive interfaces. The no format of this command is used to restore it to the default.
passive-interface [default | type number]
no passive-interface [default | type number]
Parameter
description
Default
Command
mode
Usage
guidelines
Examples
Related
commands

32.1.40 redistribute

Use this command to redistribute the external routing information.
redistribute {bgp | ospf process-id | rip | connected | static}[metric value | match
{internal | external | external 1 | external 2 | nssa-external | nssa-external 1 |
nssa-external 2}metric-type {1|2} | route-map map-tag | tag <0-4294967295> | subnets ]
Parameter Description
Set the Interfaces of this type as passive
type number
interface
Set all the interfaces as passive interfaces.
default
By default, no interface is configured as passive interface. All
interfaces are allowed to receive/send OSPF messages.
Routing process configuration mode.
To prevent other devices in the network from dynamically learning the
routing information of the device, specify the specified network
interface of this device as passive interface.
The configuration example below configures serial 1/0 as passive
interface.
DES-7210(config)# router ospf 30
DES-7210(config-router)# passive-interface serial 1/0
Command Description
Show the configuration information of the
show ip ospf
interface.
interface
Chapter 32 OSPFv2 Configuration Commands
32-43