Bgp Client-To-Client Reflection - D-Link DES-7200 Cli Reference Manual

Chapter 33 BGP4 Configuration Commands
configuration
Command
mode
Usage
guidelines
Examples
Related
commands
Platform
description

33.1.12 bgp client-to-client reflection

Use this command to enalbe the route reflection function between clients on the device. The
no form of the command disables the route reflection function between clients.
bgp client-to-client reflection
no bgp client-to-client reflection
33-10
of the path is considered as 0. This kind of routes has the highest
priority according to the known rule.
BGP configuration mode.
By default, if the path whose MED attribute is not set is received, the
MED value of this path will be taken as 0. For the smaller the MED
value, the higher the priority of the path is, the MED value of this path
reaches the highest priority. If you hope the path without MED
attribute configured has the lowest priority, this command can be
used.
DES-7210(config)# router bgp 65000
DES-7210(config-router)# bgp bestpath med
missing-as-worst
Command
show ip bgp
bgp bestpath
always-compare-med
bgp bestpath med
confed
bgp
deterministic-med
DES-7200 CLI Reference Guide
Description
Show the BGP route entry.
Compare the MED value of the path of the
peer from different ASs while selecting the
optimal path.
Set the priority of the path without MED
attribute as the lowest while selecting the
optimal path.
Compare the path of the peer from the
same AS while selecting the optimal path.