Clear Ipv6 Neighbors; Tunnel Mode Ipv6Ip - D-Link DES-7200 Cli Reference Manual

Chapter 36 IPv6 Configuration Commands
Command
mode
Usage
guidelines
Examples
Related
commands

36.1.20 clear ipv6 neighbors

Use this command to clear the dynamically learned neighbors.
clrear ipv6 neighbors
Command
mode
Usage
guidelines
Examples
Related
commands

36.1.21 tunnel mode ipv6ip

Use this command to configure static IPv6 tunnel mode. Use the no form of this command
to restore it to the default IPv6 tunnel mode.
tunnel mode ipv6ip [6to4 | isatap]
no tunnel mode
36-18
Interface configuration mode.
The transmission rate of any ICMPv6 error message is limited. By
default, it is 100pps.
DES-7210(config)# interface vlan 1
DES-7210(config-if)# ipv6 redirects
Command Description
show ipv6
Show the interface information.
interface
Privileged mode.
This command can be used to clear all the neighbors dynamically
learned by the RDP. Note that the static neighbors will not be cleared.
DES-7210# clear ipv6 neighbors
Command Description
ipv6 neighbor Configure the neighbor.
show ipv6
Show the neighbor information.
neighbors
DES-7200 CLI Reference Guide