D-Link DES-7200 Cli Reference Manual page 1105

DES-7200 CLI Reference Guide
Default
Command
mode
Usage
guidelines
Examples
Related
commands
59.2 Showing and Monitoring Commands
The following commands are included:

show interfaces [interface-id] switchport backup [detail]

show mac-address-table update group [detail]
59.2.1 show interfaces [interface-id] switchport backup [detail]
Use this command to show the dual link backup information on the interfaces.
show interfaces [interface-id] switchport backup [detail]
Parameter
description
ID.
The default group number is 1.
By default, no mac-address-table update group is
configured.
Interface configuration mode.
In order to reduce the flood due to the MAC address update and the
influence on the normal data transmission of the switch, DES-7210
products add a configuration of MAC address update group. Only if all
the interfaces are added to a MAC address update group, the
downstream data transmission be restored rapidly.
DES-7210(config-if)# mac-address-table update group 2
Command
show
mac-address-table
update group
detail
Parameter Description
Interface-id The interface id of the dual link backup.
detail Show the detailed information about the
Chapter 59 REUP Configuration Commands
Description
Show the mac-address-table update group
information.
59-5