Neighbor Weight - D-Link DES-7200 Cli Reference Manual

Chapter 33 BGP4 Configuration Commands
description

33.1.67 neighbor weight

Use this command to set the weight for the specific neighbor. The no form of the command
removes the setting.
neighbor {ip-address|peer-group-name} weight number
no neighbor {ip-address|peer-group-name} weight number
Parameter
description
Default
configuration
Command
mode
Usage
guidelines
Examples
Related
commands
Platform
description
33-66
Parameter Description
peer-address IP address of the peer
Name of the peer group of up to 32
peer-group-name
characters
number Weight in the range of 0 to 65535.
No weight is configured for the specific neighbor by default. In this
case, the learned neighbor weight is 0 and the locally generated
weight is 32768 initially.
BGP configuration mode.
When the command is used, the routes from the neighbor use this
value as the initial weight value. The higher the weight, the higher the
priority is.
Executing the set weight command in the route map of the neighbor
will overwrite this value.
DES-7210(config-router)# neighbor 10.1.1.1 weight 73
Command Description
router bgp Enable the BGP protocol.
neighbor
Configure the BGP peer.
remote-as
DES-7200 CLI Reference Guide