Vrrp Preempt - D-Link DES-7200 Cli Reference Manual

Chapter 57 VRRP Configuration Commands
Default
configuration
Command
mode
Usage
guidelines
Examples
Related
commands
57.1.5

vrrp preempt

Use this command to set the preemption mode of the VRRP group. The no command
disables the VRRP preemption function.
vrrp group preempt [delay seconds]
no vrrp group preempt[delay]
Parameter
description
57-24
Disabled.
Interface configuration mode.
If the secondary parameter is not used, the IP address set here will
become the master IP address of the virtual device. Note that if the
VRRP group is using the IP address of the Ethernet interface, an
error occurs when you remove the IP address of the VRRP group with
the no command, because there are duplicated IP address in the
LAN.
The example below enables the VRRP function on Ethernet interface
0. The VRRP group number is 1, primary IP address of the virtual
device is 10.0.1.20 and secondary IP address is 10.0.2.20.
interface FastEthernet 0/0
no switchport
ip address 10.0.1.1 255.255.255.0
ip address 10.0.2.1 255.255.255.0 secondary
vrrp 1 ip 10.0.1.20
vrrp 1 ip 10.0.2.20 secondary
Command
DES-7210# show vrrp
[ brief | group ]
Parameter
group
delay seconds
DES-7200 CLI Reference Guide
virtual device.
Description
Show the VRRP configuration.
Description
VRRP group number
(Optional)Specify the delay before a