Rerp Hello-Interval - D-Link DES-7200 Cli Reference Manual

Chapter 58 RERP Configuration Commands
Usage
guidelines
Examples
Related
commands
58.1.2

rerp hello-interval

Use this command to configure the interval at which the RERP sends the Hello message on
the primary port. Use the no form of this command to restore it to the default value.
rerp hello-interval interval
no rerp hello-interval
Parameter
description
Default
Command
mode
Usage
guidelines
Examples
Related
commands
58-2
Only when the global RERP is enabled, the configuration of other
parameters will take effect.
The following example shows how to enable RERP:
DES-7210(config)# rerp enable
Command Description
rerp region Create a RERP domain.
Parameter Description
interval Interval of sending the Hello message, in the
range 1 to 6 seconds
1 seconds.
Global configuration mode.
The detection interval must be less than the failure time.
The following example shows how to set the interval as 2s:
DES-7210(config)# rerp hello-interval 2
Command Description
rerp fail-interval Configure the timeout time.
DES-7200 CLI Reference Guide