Arp-Check - D-Link DES-7200 Cli Reference Manual

DES-7200 CLI Reference Guide
Command
mode
Usage
guidelines
Examples
Related
commands
Platform
description
43.1.7

arp-check

Use this command to enable the ARP check function. Use the no form of the command to
disable this function. Use default to restore the mode by default.
[no|default] arp-check [cpu|auto]
Parameter
description
Default
configuration
Command
mode
Chapter 43 Port-based Flow Control Configuration Commands
Interface configuration mode.
The secure address of IP address and MAC address shares hardware
with the ACL. Once the ACL or 802.1x is applied on the port, the number
of the secure addresses indicating IP address should decrease.
The example below describes how to configure a secure address for
interface gigabitethernet 1/1: 00d0.f800.073c and bind it with an IP
address:192.168.12.202:
DES-7210# configure terminal
DES-7210(config)# interface gigabitethernet 1/1
DES-7210(config-if)# switchport mode access
DES-7210(config-if)# switchport port-security
DES-7210(config-if)# switchport port-security
mac-address 00d0.f800.073c ip-address 192.168.12.202
Command
show port-security
DES-7200 series supports up to 1000 secure addresses globally or up to
84 secure addresses (IP address binding) per port.
Parameter
cpu
auto
Auto mode.
Interface configuration mode.
Description
Show port security settings.
Description
check the packets sent to the CPU.
Restore the mode by default.
43-7