D-Link DES-7200 Cli Reference Manual page 1164

Chapter 66 Syslog Configuration Commands
Usage
guidelines
Examples
66-20
In the extended FLASH, the log file means the files with the prefix
―//f2/‖, ―//f3/'. This command only allows you to view the log files. You
cannot use this command to view other non-log files.
The following command shows the result of the show logging command:
DES-7210# show logging
Syslog logging: enabled
Console logging: level debugging, 4 messages logged
Monitor logging: level informational, 0 messages logged
Buffer logging: level debugging, 6 messages logged
Timestamp debug messages: datetime
Timestamp log messages: disabled
Sequence log messages: enable
Trap logging: level debugging, 2 message lines logged,0 reserved,0 fail
logging to 202.101.11.22
logging to 192.168.200.112
Log Buffer (Total 4096 Bytes) : have written 680
00001 2004-11-17 10:20:59
FastEthernet 0/0, changed state to up
00002 2004-11-17 10:20:59 DES-7210: %7:%LINE PROTOCOL CHANGE: Interface
FastEthernet 0/0, changed state to UP
00003 2004-11-17 10:57:18
FastEthernet 0/1, changed state to administratively down
00004 2004-11-17 10:57:21
FastEthernet 0/1, changed state to down
00005 2004-11-17 10:57:41
FastEthernet 0/1, changed state to administratively down
00006 2004-11-17 10:57:43
FastEthernet 0/1, changed state to down
The log messages are described as below:
Field
Syslog logging
Console logging
Monitor logging
Buffer logging
Timestamp debug messages
DES-7200 CLI Reference Guide
DES-7210: %7:%LINK CHANGED: Interface
DES-7210: %7:%LINK CHANGED: Interface
DES-7210: %7:%LINK CHANGED: Interface
DES-7210: %7:%LINK CHANGED: Interface
DES-7210: %7:%LINK CHANGED: Interface
Description
Logging flag: enabled or disabled
Level of the logs printed on the console,
and statistics
Level of the logs printed on the VTY
window, and statistics
Level of the logs recorded in the
memory buffer, and statistics
Timestamp format of the Debug