Interface Rate-Limit - D-Link DES-7200 Cli Reference Manual

Chapter 56 QoS Configuration Command
Default
configuration
Command
mode
Examples
Related
commands
Use this command to configure rate limitation on the interface. Use the no form of the
command to restore it to the default.
rate-limit {input | output}
no rate-limit
Parameter
description
Command
mode
Examples
56-10
products.
cos COS value ranging 0 to 7
Restore to the default value.
no
See the default configuration.
Global configuration mode.
DES-7210(config)# mls qos map dscp-cos 8 10 16 18 to 0
Command Description
show mls qos Show DSCP-COS, COS-DSCP and
maps IP-prec-DSCP maps.

56.2.10 interface rate-limit

bps burst-size
Parameter Description
input Specify the input speed limit.
output Specify the output speed limit.
bps Bandwidth limitation per second
burst-size Burst traffic limit (Kbyte). Its range
varies with products.
Restore to the default value.
no
Interface configuration mode.
DES-7210(config)# interface fastEthernet 0/1
DES-7210(config-if)# rate-limit input 1000000 4096
DES-7200 CLI Reference Guide