Timers Lsa-Group-Pacing - D-Link DES-7200 Cli Reference Manual

Chapter 32 OSPFv2 Configuration Commands
Related
commands

32.1.44 timers lsa-group-pacing

Use this command to configure the LSA grouping and then refresh the whole groups as well
as the update interval for aged link state. The no form of the command restores it to the
default.
timers lsa-group-pacing seconds
no timers lsa-group-pacing
Parameter
description
Default
Command
mode
Usage
guidelines
Examples
32-48
DES-7210(config-router)# network 172.16.24.0 0.0.0.255 area 0
DES-7210(config-router)# area 1 nssa
Command Description
Configure route convergence on the OSPF area
area-range
border device.
Parameter Description
This parameter is used for LSA pacing,
seconds checksum calculation, and aging interval.
The range is 0 to 600s and 10 to1800s.
240 seconds.
Routing process configuration mode.
The updated information in the pacing switch (LSA), checksum
calculation, and aging interval are for more efficient switch use. The
default is 4 minutes. This parameter needs not to be adjusted often.
The optimum group pacing interval is inversely proportional to the
number of LSAs that need to be calculated. For example, if you have
approximately 10,000 LSAs in the database, decreasing the pacing
interval would be better. If the switch has a small database (40 to 100
LSAs), increasing the pacing interval to 10 to 20 minutes might be
better. To configure OSPF LSA pacing, follow these steps in the
privileged mode:
The configuration example below configures the pacing time as 120s.
DES-7210(config)# device ospf 20
DES-7210 (config-router)# timers lsa-group-pacing 120
DES-7200 CLI Reference Guide