Ipv6 Traffic-Filter - D-Link DES-7200 Cli Reference Manual

Chapter 54 ACL Configuration Commands
Parameter
description
Default
configuration
Command
mode
Usage
guidelines
Examples
Related
commands
Platform
description

54.1.14 ipv6 traffic-filter

Use this command to apply the specified IPV6 ACL on the specified interface. Use the no
form of the command to remove the application.
ipv6 traffic-filter name {in|out}
no ipv6 traffic-filter name {in|out}
54-32
Parameter
id
name
in
out
No ACL is applied on the interface.
Interface configuration mode.
N/A.
The following example shows how to apply the access-list
accept_00d0f8xxxxxx only to Gigabit interface 1:
DES-7210(config)# interface GigaEthernet 0/1
DES-7210(config-if)# expert access-group
accept_00d0f8xxxxxx_only in
Command Description
show Show the ACL configuration.
access-group
The software version must be R10.0 and higher.
DES-7200 CLI Reference Guide
Description
ID of the expert ACL (2700 to 2899)
Name of the expert ACL
Filter the inputting packets of the interface
Filter the outputting packets of the interface