Chapter 61 TPP Configuration Commands
61.1.2
tp-guard port enable
Use this command to enable the topology protection function on the port. Use the no form
of this command to disable the function.
[no] tp-guard port enable
Parameter
description
Default
configuration
Command
mode
Usage
guidelines
Examples
Related
commands
61.2 Showing Related Commands
61.2.1
show tpp
Use this command to show the configuration of topology protection.
show tpp
61-2
N/A.
N/A.
Interface configuration mode.
If both the global topology protection function and the topology
protection function of the port are enabled, the remote device of this
port will be notified when the CPU utilization of the local device is too
high or there are other problems with the local device. This command
is applicable to the layer 2 switching interfaces and routing interfaces.
Other interfaces (including AP member port) do not support this
command.
The following example shows how to configure the topology
protection function for the port:
DES-7210(config-if)# tp-guard port enable
DES-7210(config-if)# no tp-guard port enable
Command
Description
topology guard
Enable the topology protection function globally.
DES-7200 CLI Reference Guide