Switchport Port-Security Mac-Address - D-Link DES-7200 Cli Reference Manual

Chapter 43 Port-based Flow Control Configuration Commands
Default
configuration
Command
mode
Usage
guidelines
Examples
Related
commands
43.1.6

switchport port-security mac-address

Use this command to configure the secure address table. Use the no form of the command
to remove the configuration or restore it to the default setting.
switchport port-security [mac-address mac-address [ip-address {ip-address|
ipv6-address}]] | [maximum value]
no switchport port-security [mac-address mac-address [ip-address {ip-address
|ipv6-address}]] | maximum]
Parameter
description
Default
configuration
43-6
No secure address is aged.
Interface configuration mode.
In interface configuration mode, use no switchport port-security aging
time to disable the aging for security addresses on the port. Use the no
switchport port-security aging static to apply the aging time to only the
dynamically learned security address.
Use show port-security to display configuration.
DES-7210(config)# interface gigabitethernet 1/1
DES-7210(config-if)# switchport port-security aging time 8
DES-7210(config-if)# switchport port-security aging static
Command
show port-security
Parameter
mac-address mac-address
ip-address ip-address
ip-address ipv6-address
maximum value
N/A.
DES-7200 CLI Reference Guide
Description
Show port security settings.
Description
Set the secure MAC address.
Set the secure IP address.
Set the secure ipv6 address.
Set the maximum number of the
addresses in the secure address
table.