Log-Adj-Changes - D-Link DES-7200 Cli Reference Manual

Chapter 32 OSPFv2 Configuration Commands
Examples
Related
commands

32.1.32 log-adj-changes

Use this command to enable the logging of the neighbor state changes. The no or default
form of the command is used to disable it.
log-adj-changes [detail]
no log-adj-changes [detail]
Parameter
description
Parameter
description
Default
Command
mode
Examples
32-36
this parameter shall consider the send and line transmission delay of
the interface. For low-rate lines, the transmission delay of the
interface shall be slightly larger. The LSU message transmission
delay of virtual link is defined through the area virtual-link command
followed with the keyword retransmit-interval.
The DES-7200 software will resend or request resending the LSA
with Age up to 3600. If no refresh is obtained in time, the aged LSA
will be cleared from the link state database.
The configuration example below configures the transmission delay
of serial1/ 0 as 5.
DES-7210(config)interface serial 1/0
DES-7210(config-if)#ip ospf transmit delay 10
Command Description
area virtual-link Define an OSPF virtual link.
Parameter Description
LSU message transmission delay ( in seconds).
Seconds
The default is 1 second.
Parameter Description
detail Record the detail of changes.
Enabled. Without the detail parameter, the system records the logs
that the neighbor enters the full state or leaves the full state.
Routing process configuration mode.
The configuration example below logs the neighbor status change.
DES-7210(config)# router ospf 1
DES-7210(config-router)# log-adj-changes
DES-7200 CLI Reference Guide