Vrrp Timers Advertise - D-Link DES-7200 Cli Reference Manual

Chapter 57 VRRP Configuration Commands
Parameter
description
Default
configuration
Command
mode
Usage
guidelines
Examples
Related
commands
57.1.7

vrrp timers advertise

Use this command to specify the interval for the master device to send the VRRP
advertisement. The no form of this command restores it to the default.
vrrp group timers advertise interval
no vrrp group timers advertise
Parameter
description
57-26
Parameter
group
level
By default, the VRRP function is not enabled on the
the VRRP function is enabled, the default priority of the VRRP group
is 100.
Interface configuration mode.
None.
The example below sets the priority of VRRP group 1 as 254.
vrrp 1 priority 254
Command
DES-7210(config-if)#
vrrp group ip ipaddress
[ secondary ]
DES-7210(config-if)#
vrrp group preempt
[ delay seconds ]
Parameter
group
interval
DES-7200 CLI Reference Guide
Description
VRRP group number
VRRP group priority
Description
Enable the VRRP function and
set the IP address for the
virtual device.
Set the VRRP in the
preemption mode.
Description
VRRP group number
Advertisement interval (in seconds)
interface. Once