Ipv6 Source-Route - D-Link DES-7200 Cli Reference Manual

DES-7200 CLI Reference Guide
no ipv6 neighbor ipv6-address interface-id
Parameter
description
Default
configuration
Command
mode
Usage
guidelines
Examples
Related
commands
36.1.6

ipv6 source-route

Use this command to forward the IPv6 packet with route header. The no form of this
command disables the forwarding.
Parameter Description
IPv6 address of the neighbor. It must follow the
ipv6-address
address format defined in RFC2373.
Network interface of the neighbor (including
interface-id
routed Port, L3 AP interface, or SVI interface).
Hardware address of the neighbor. It shall be a
48-bit MAC address in the format of
hardware-address
XXXX.XXXX.XXXX, where ―X‖ is a hexadecimal
number.
No static neighbor is configured.
Global configuration mode.
Similar to the ARP command, the static neighbor can only be
configured on an IPv6 interface.
If the neighbor to be configured has been learned through NDP and
has been stored in the neighbor list, the dynamically generated
neighbor will be automatically switched to a static one. The
configured static neighbor is always in the Reachable status.
Use clear ipv6 neighbors to clear all the neighbors dynamically
learned through NDP.
Use show ipv6 neighbors to view the neighbor information.
DES-7210(config)# ipv6 neighbor 2001::1 vlan 1 00d0.f811.1111
Command Description
show ipv6
Show the neighbor information.
interface
clear ipv6
Clear the neighbors learned dynamically.
neighbors
Chapter 36 IPv6 Configuration Commands
36-5