Show Ip Route - D-Link DES-7200 Cli Reference Manual

DES-7200 CLI Reference Guide
Usage
guidelines
Examples
34.2.4

show ip route

Use the command to view the configuration of the IP routing table.
show ip route [[vrf vrf_name] [network [mask] | count | protocol [process-id] | weight ]]
Parameter
description
Default
configuration
Command
mode
Usage
guidelines
Chapter 34 Protocol-independent Configuration Commands
If no prefix list is specified, the configurations of all the prefix lists are
displayed, otherwise only the configuration of the specified prefix list
is displayed.
DES-7210# show ip prefix-list
ip prefix-list name : test
seq pre: 2 entries
seq 5 permit 192.168.564.0/24
seq 10 permit 192.2.2.0/24
Parameter Description
(Optional) Show the route information of the
vrf vrf_name
VRF.
(Optional) Show the route information to the
network
network.
(Optional)Show the route information to the
mask
network of this mask.
count (Optional)Show the number of existent routes.
(Optional) Show the route information of specific
protocol
protocol.
process-id (Optional) Routing protocol process ID.
(Optional) Show the route information of non
weight
deault weight.
All routes are displayed by default.
Privileged mode, global configuration mode, interface configuration
mode, routing protocol configuration mode, route map configuration
mode.
This command can show route information flexibly.
34-77