DES-7200 CLI Reference Guide
Command
Syntax
Parameter
description
Default
configuration
Command
mode
Usage
guidelines
Examples
38.1.6
ip igmp immediate-leave group-list
In the IGMPversion2 and IGMPversion3 versions, use this command to shorten the delay of
leaving a group. This command is used when a single receiving host is connected to a
single interface. The no form of this command is used to disable this function.
Command
syntax
Parameter
description
Default
ip igmp static-group group-address
no ip igmp static-group group-address
Parameter
group-address
The switch is not added to the multicast group manually.
Interface configuration mode.
This command directly adds an interface to a multicast group. The
difference from join-group is that it directly adds an interface to the
group without interacting with a report message.
You can use this command to add an interface to a group.
Following example is to add a host group member manually:
DES-7210# configure terminal
DES-7210(config)# interface fast 0/1
DES-7210(config-if)# ip igmp static-group 233.3.3.3
ip igmp immediate-leave group-list access-list
no ip igmp immediate-leave group-list
Parameter
Description
access-list
Name of access control list.
Disabled.
Chapter 38 IGMP Configuration Commands
Description
Multicast group IP address.
38-5