Domain-Name; Ip Address Dhcp - D-Link DES-7200 Cli Reference Manual

Chapter 23 DHCP Configuration Commands
dns-server { ip-address [ ip-address2...ip-address8 ] | use-dhcp-client interface-type
interface-number }
no dns-server
Parameter
description
Default
Command
mode
Usage
guidelines
Examples
Related
commands
23-6
Parameter
ip-address
ip-address2...ip-address8
use-dhcp-client
interface-type
interface-number
No DNS server is defined by default.
DHCP address pool configuration mode.
When more than one DNS server is defined, the former will possess
higher priory, so the DHCP client will select the next DNS server only
when its communication with the former DNS server fails.
If the DES-7200 software also acts as the DHCP client, the DNS
server information obtained by the client can be transmitted to the
DHCP client.
The configuration example below specifies the DNS server
192.168.12.3 for the DHCP client.
dns-server 192.168.12.3
Command

domain-name

ip address dhcp

ip dhcp pool
DES-7200 CLI Reference Guide
Description
Define the IP address of the DNS server.
At least one IP address should be
configured.
(Optional) Up to 8 DNS servers can be
configured.
Use the DNS server learned by the
DHCP client of the DES-7200 software
as the DNS server of the DHCP client.
Description
Define the suffix domain name of the
DHCP client.
Enable the DHCP client on the interface to
obtain the IP address information.
Define the name of the DHCP address
pool and enter into the DHCP address
pool configuration mode.