Usb Remove - D-Link DES-7200 Cli Reference Manual

Chapter 69 USB configuration Commands
69.1.2

usb remove

usb remove device_ID
Parameter
description
Default
Command
mode
Usage
guidelines
Examples
69-2
USB Mass Storage Device: Name of the device
ID: The ID number of the device. (Useful when removing it)
Lun: A logical unit number of the device, and the following ID is the ID
of the logical unit.
Disk Partitions: the partition information of the device. As shown in
the above output, this device has one partition, and the partition file is
/dev/uba/disc0/part1, which is mounted to the directory /mnt/uba.
You can use the file system command cd /mnt/uba to go to this
directory and perform operations on the contents in this partition.
Parameter Description
device_ID Device ID of USB to be removed.
N/A.
Privileged EXEC mode.
Before pulling out the USB device, you need to remove the device
using a command, so as to prevent errors that may occur because
the system is using the device. If the device is removed successfully,
the system will show a prompt, when you can pull out the device. If
the device cannot be pulled out, it indicates that the system is using
this USB device, so you have to wait a moment before removing it
again.
The following example demonstrates how to remove the USB device
mentioned in the example in the previous section.
DES-7210# usb remove 778
OK, now you can pull out the device 778.
0:1:1:38 DES-7210: USB-5-USB_DISK_REMOVED: USB Device <USB Mass
Storage Device> Removed!
At this moment, the usb device can be plugged out.
DES-7200 CLI Reference Guide