Mpls Ldp Max-Path-Vector - D-Link DES-7200 Cli Reference Manual

Chapter 42 MPLS Configuration Commands
description
Default
configuration
Command
mode
Usage
guidelines
Examples
Related
commands

42.1.21 mpls ldp max-path-vector

Use this command to configure the maximum path vector value allowed for loop detection
on each interface. Use the no form of this command to restore the default value.
mpls ldp
no mpls ldp
Parameter
description
42-20
<0-255>
The default value is 0, meaning that the label requests will not be
retransmitted.
Interface configuration mode.
This command is invalid for the label request times in the built LDP
session on the interface, and valid for newly-built LDP session. The
value 0 means that the label requests will not be retransmitted.
DES-7210(config)# interface vlan 10
DES-7210(config-if)# mpls ldp max-label-requests 5
Command
mpls-ldp-distribution
-mode
max-path-vector <0-254>
max-path-vector
Parameter
<0-254>
DES-7200 CLI Reference Guide
Maximum request times
Description
Configure the label distribution mode
Description
Maximum path vector value