Ip Igmp Proxy-Service - D-Link DES-7200 Cli Reference Manual

DES-7200 CLI Reference Guide
Command
mode
Usage
guidelines
Examples

38.1.16 ip igmp proxy-service

Use this command to enable the service function of all downlink mroute-proxy ports. If you
run this command on an interface, the interface becomes the uplink port of the
corresponding mroute-proxy that associates its downlink ports and maintains the group
information reported by the downlink ports.
ip igmp proxy-service
no ip igmp proxy-service
Default
configuration
Command
mode
Usage
guidelines
Global configuration mode.
Use this command to globally configure the maximum number of
IGMP group records. The messages of the members exceeding the
threshold will not be saved in the IGMP buffer and will not be
forwarded.
This command can be configured globally or on the interface The
messages of the members will be ignored if they exceed the interface
or global configuration.
The following example sets the maximum number to 300:
DES-7210(config) # ip igmp limit 300
All interfaces are not in the proxy-serice status.
Interface configuration mode.
The command can configure at most 32 interfaces. Each
proxy-service port can associate with the maximum of 255 downlink
ports. When receiving a query message, the proxy-service port
responds according to the member information maintained by the port
itself. The member information maintained by the proxy-service port
is collected from the interface configured with mroute-proxy.
Therefore, if a port is configured with proxy-server, the port performs
the host activities, but not the device activities.
If switchport operation is performed on an interface, the ip igmp
mroute-proxy interface command configured on the associated
downlink ports is automatically deleted.
Chapter 38 IGMP Configuration Commands
38-13