Chapter 56 QoS Configuration Command
Platform
description
Use this command to configure whether to use strict priority(SP) or not for the queue, on the
condition that the queue uses wfq schedule algorithm. wrf-queue queue-id sp
no wrf-queue queue-id sp
Parameter
description
Default
configuration
Command
mode
Usage
guidelines
Examples
Related
commands
56-14
scheduler
The software version must be R10.1 and higher.
56.2.15 wrf-queue-sp
Parameter
Description
queue-id
Specify the DSCP value.
sp
Restore to the default value.
SP is not used.
Global configuration mode.
Use this command to enable the queue to use sp+wrf schedule
algorithm, on the condition that the queue uses wrf schedule
algorithm.
The following example enables the queue to use wrf schedule
algorithm:
DES-7210(config)# mls qos scheduler wrf
DES-7210(config)# show mls qos scheduler
The following example configures queue 1 and queue 3 to use SP:
DES-7210(config)# wrf-queue 1 sp
DES-7210(config)# wrf-queue 3 sp
DES-7210(config)# show running
Command
Description
show mls qos
Show QOS schedule method.
scheduler
DES-7200 CLI Reference Guide