Default-Information Originate (Bgp) - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 mm

default-information originate (BGP)

default-information originate
no default-information originate
Syntax
Description
Default
Command Mode
Usage Guideline
Example
Switch(config)# router bgp 65534
Switch(config-router)# default-information originate
CLI Reference Guide
Use this command to configure a Border Gateway Protocol (BGP) routing
process to distribute a default route (network 0.0.0.0), use the default-
information originate command in address family or router configuration mode.
To disable the advertisement of a default route, use the no form of this
command.
None
None
Router configuration
Address family configuration
The default-information originate command is used to configure a BGP routing
process to advertise a default route (network 0.0.0.0). A redistribution statement
must also be configured to complete this configuration or the default route will not
be advertised.
The configuration of the default-information originate command in BGP is similar
to the configuration of the network (BGP) command. The default-information
originate command, however, requires explicit redistribution of the route 0.0.0.0.
The network command requires only that the route 0.0.0.0 is present in the
Interior Gateway Protocol (IGP) routing table. For this reason, the network
command is preferred.
This example shows how to advertise the default route regardless whether a
default route exists in the configuration or not.
Verify the settings by entering the show ip protocols BGP command.
default-information originate (BGP)
137